Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R350 Installation and Service Manual
- Contents
- About this document
- PowerEdge R350 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Air shroud
- Cooling fans
- Intrusion switch
- Drive backplane
- Cable routing
- Drives
- Optional optical drive
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional BOSS S2 card
- System battery
- Front mounting front PERC module
- Optional internal USB card
- Power supply unit
- Power interposer board
- Optional IDSDM module
- MicroSD card
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Expansion card installation guidelines
Figure 45. Expansion card slot connectors
1. Internal PERC connector
2. Butterfly riser connector
The following table describes the expansion card riser configurations:
Table 21. Expansion card riser configurations
Expansion card
risers
PCIe Slots Controlling
processor
Height Length Slot width
NA INT Processor 1 Half Height Half length x8
Riser 2 Processor 1 Half Height Half length x16
Riser 1 Processor 1 Half Height Half length x8
Installing and removing system components 55