Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R350 Installation and Service Manual
- Contents
- About this document
- PowerEdge R350 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Air shroud
- Cooling fans
- Intrusion switch
- Drive backplane
- Cable routing
- Drives
- Optional optical drive
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional BOSS S2 card
- System battery
- Front mounting front PERC module
- Optional internal USB card
- Power supply unit
- Power interposer board
- Optional IDSDM module
- MicroSD card
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 15. Connector descriptions for 8 x 2.5-inch drive SATA backplane with internal PERC
From To
BP_PWR_1 (backplane power connector) SIG_PWR_1 (PIB power connector)
BP_DST_SA1 (backplane SATA connector, cable marking BP
SA1)
CTRL_SRC_SA1 (Signal connector on the PERC)
Figure 27. Cable routing - 8 x 2.5-inch drive SAS or SATA backplane with PIB
Table 16. Connector descriptions for 8 x 2.5-inch drive SAS or SATA backplane with PIB
From To
BP_PWR_1 (backplane power connector) SIG_PWR_1 (PIB power connector)
SYS (Power interposer board connector) P1 (System power connecter)
CPU (Power interposer board connector) P2 (CPU Power connecter)
PIB_SIG_1 (Power interposer board signal connector) J_PIB1 (PIB connector)
38 Installing and removing system components