Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R350 Installation and Service Manual
- Contents
- About this document
- PowerEdge R350 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Air shroud
- Cooling fans
- Intrusion switch
- Drive backplane
- Cable routing
- Drives
- Optional optical drive
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional BOSS S2 card
- System battery
- Front mounting front PERC module
- Optional internal USB card
- Power supply unit
- Power interposer board
- Optional IDSDM module
- MicroSD card
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 25. Cable routing - 4 x 3.5-inch drive SAS or SATA backplane with fPERC, and BOSS card
Table 14. Connector descriptions for 4 x 3.5-inch drive SAS or SATA backplane with fPERC, and BOSS
card
From To
SL2_PCH_PA2 ( BOSS signal connector on the system board) J_PCIE_1 ( Signal connector on BOSS card)
BOSS_PWR ( Power connector on system board) J_PWR_1 ( Power connector on BOSS card)
ODD_PWR_1 (ODD power connector) HDD/ODD_PWR (HDD/ODD card power connector)
ODD_SIGNAL (ODD signal connector) SATA_ODD (ODD SATA connector)
CTRL_DST_PA1 (fPERC connector on the backplane) Internal PERC slot on the system board
Figure 26. Cable routing - 8 x 2.5-inch drive SATA backplane with internal PERC
Installing and removing system components
37