Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R350 Installation and Service Manual
- Contents
- About this document
- PowerEdge R350 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Air shroud
- Cooling fans
- Intrusion switch
- Drive backplane
- Cable routing
- Drives
- Optional optical drive
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional BOSS S2 card
- System battery
- Front mounting front PERC module
- Optional internal USB card
- Power supply unit
- Power interposer board
- Optional IDSDM module
- MicroSD card
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 12. Connector descriptions for 4 x 3.5-inch drive SAS or SATA backplane
From To
BP_PWR_1 (backplane power connector) SIG_PWR_1 (PIB board power connector)
BP_DST_SA1 (backplane SATA connector, cable marking BP
SA1)
CTRL_SRC_SA1 (Signal connector on the PERC)
Figure 24. Cable routing - 4 x 3.5-inch drive SAS or SATA backplane with butterfly riser, BOSS card
Table 13. Connector descriptions for 4 x 3.5-inch drive SAS or SATA backplane with Butterfly riser, BOSS
card
From To
J_PWR_1 (BOSS card connector) BOSS_PWR (Power connector for BOSS card on system
board)
LEFT EAR (LEFT EAR connector) LEFT_LED (LEFT_LED connector)
RIGHT EAR (RIGHT EAR connector) CTRL_PNL (Control panel connector)
INTRUDER R_INTRUSION
36 Installing and removing system components