Install Guide

PS6210 安 装和 设置 指南
4 软件配置
3. 出现提示后，输入y以启动设置公用程序。
4. 出现提示后，请根据 第 17 页上 收集配置信息 中的信息输入阵列和组配置信息。按Enter键以
接受默认值。输入问号(?)以获取帮助。
注 ： 输入组IP地址后，阵列需要搜索网络，可能会出现短暂的延迟。
设置完成后，必须先设置成员的RAID策略才能使用磁盘存储空间。转到 第 20 页上 设置成员的
RAID 策略 。
以下示例显示使用设置公用程序初始化阵列并创建组。
示 例 - 使 用 设 置 公 用 程 序
Login: grpadmin
Password: xxxxxxxx
The setup utility establishes the initial network and storage configuration for a storage array
and then configures the array
as a member or a new or existing group of arrays.
For help, enter a question mark (?) at a prompt.
Welcome to Group Manager
Copyright 2013 Dell Inc.
It appears that the storage array has not been configured.
Would you like to configure the array now?(y/n) [n] y
Group Manager Setup Utility
Do you want to proceed (yes | no) [no]? yes
Initializing.This may take several minutes to complete.
Enter the network configuration for the array:
Member name []: member1
Network interface [eth0]: eth0
IP address for network interface []: 192.17.2.41
Netmask [255.255.255.0]:
Default gateway [192.17.2.1]:
Enter the name and IP address of the group that the array will join.
Group name []: group1
Group IP address []: 192.17.2.20
Searching to see if the group exists.This may take a few minutes.
The group does not exist or currently cannot be reached.Make sure you have entered the correct
group IP address and group name.
Do you want to create a new group (yes | no) [yes]?yes
Group Configuration
Group Name: group1
Group IP address: 192.17.2.20
Do you want to use the group settings shown above (yes | no) [yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
Saving the configuration ...
Waiting for configuration to become active......Done
Group member member1 now active in the group.
Group group1 has been created with one member.
19