Install Guide

PS6210 Install and Setup Guide
4 Software Configuration
Note: Ifthearraydoesnotrespond,contactyourPSSeriessupportproviderforinformationonhowto
proceed.
2. Attheloginprompt,entergrpadminforboththeaccount(login)nameandthepassword.Passwordsdonot
appearonthescreen.
3. Whenprompted,enterytostartthesetuputility.
4. Whenprompted,enterthearrayandgroupconfigurationinformationfromCollect Configuration Information
on page 17.PresstheEnterkeytoacceptadefaultvalue.Enteraquestionmark(?)togethelp.
Note: TheremaybeashortdelayafterenteringthegroupIPaddressasthearraysearchesthenetwork.
Aftersetupcompletes,youmustsetthemember’sRAIDpolicyinordertousethediskstorage.GotoSet the
Member RAID Policy on page 20.
Thefollowingexampleshowsusingthesetuputilitytoinitializeanarrayandcreateagroup.
EXAMPLE - Using the setup Utility
Login: grpadmin
Password: xxxxxxxx
The setup utility establishes the initial network and storage configuration for a storage array
and then configures the array
as a member or a new or existing group of arrays.
For help, enter a question mark (?) at a prompt.
Welcome to Group Manager
Copyright 2013 Dell Inc.
It appears that the storage array has not been configured.
Would you like to configure the array now? (y/n) [n] y
Group Manager Setup Utility
Do you want to proceed (yes | no) [no]? yes
Initializing. This may take several minutes to complete.
Enter the network configuration for the array:
Member name []: member1
Network interface [eth0]: eth0
IP address for network interface []: 192.17.2.41
Netmask [255.255.255.0]:
Default gateway [192.17.2.1]:
Enter the name and IP address of the group that the array will join.
Group name []: group1
Group IP address []: 192.17.2.20
Searching to see if the group exists. This may take a few minutes.
The group does not exist or currently cannot be reached. Make sure you have entered the correct
group IP address and group name.
Do you want to create a new group (yes | no) [yes]? yes
Group Configuration
Group Name: group1
Group IP address: 192.17.2.20
Do you want to use the group settings shown above (yes | no) [yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
19