Install Guide

PS4210 Installation Guide 3 Connecting the Array Cables
1. Findthepowerswitch,locatedeitherbelowthepowerplug.SeeFigure8.
2. PressthepowerswitchtotheONposition.Thepowerindicatorswilllight.
Batterieswillstarttochargeandsomehardwarecomponentswillstarttosynchronize.LEDs
willindicatethesenormalactivities.Thebatterybackupunitinstalledineachcontrolleris
shippedinapartiallydischargedstate.
Thefirsttimethesystemispoweredon,abootdelayofupto30minutesmightbeexperienced
whilethebatteryischargedtofullcapacity.
ThelocationoftheLEDsisshowninthefollowingillustration.Table4providesLED
descriptions.
Figure 8: AC Power Supply Switch and LEDs
Table 4: Power Supply LED Descriptions
Callout Description
1
PowerSupplystatus.ThisLEDislit(green)whentheswitchisonandthepower
supplyisprovidingpowertothearray.
2 Error.ThisLEDislit(amber)ifthepowersupplyhasaproblem.
3
InputPower.ThisLEDislit(green)aslongasmainpowerisconnectedtothepower
supply.
Set Up a Serial Connection to the Array
Ifyouplantousethesetuputilitytoconfigurethesoftware,youmustsetupaserialconnection
betweenthearrayandacomputer.IfyouplantousetheRemoteSetupwizard,youdonotneeda
serialconnection.ForinformationaboutRemoteSetupwizardrequirements,seetheHost
Integration Tool for Microsoft® Installation and User's GuideortheHost Integration Tool for
Linux® Installation and User's Guide.
Theserialcableshippedwiththearrayisastandardnull-modemcablewithafemaleDB9
connectoroneachend.Youmighthavetomakeorbuyanadaptercable(oneDB9connectorand
oneRJ45connector)toconnectthearraytosometerminalservermodels.SeeSerial Cable
Pinout Information on page 15.
Attachthecabletotheserialportontheactivecontrolmoduleandtoaconsoleterminalora
computerrunningaterminalemulator.TheactivecontrolmodulehastwogreenLEDSandthe
secondarycontrolmodulehasonegreenandoneamberLED.
13