Owners Manual

Hardware Owner's Manual

2 Maintaining Drives

4. Push the drive completely into the slot (callout 2). The drive handle will begin to close onto the drive (callout

3).

5. Push in the handle until you hear a click (callout 4).

Figure 9: Installing a 2.5-inch Drive

Verify that the new drive is operational by examining the LEDs on the front panel, as described in Interpreting

Drive LEDs on page 8. In addition, examine the GUI Member Disks window and the CLI member select show

disks command output.

Removing a 3.5-inch Drive

1. Remove the bezel. See Removing the Bezel on page 3.