Install Guide
설 치 및 설 정 안 내 서
4 소프트웨어 구성
3. 입력화 면이 나타 나면 ,y를입 력하 여setup(설치)유틸 리티 를시작합니다.
4. 메시지가표 시되 면1페이지의19
페이 지의
"
구성
정보
수집
"에서배열및그 룹구 성정보를입
력합니다.기 본값 을적 용하 려면 Enter키를누릅니다.도움 말을 확인 하려 면물음표(?)를입
력합니다.
주 : 어레이가네트워크를검색 하는 과정 으로 인해 그룹IP주 소를 입력한후약 간의 지연 이
발생될수있 습니 다.
설치가완 료되 면디스크저 장소 를사 용하 기위 해서 는멤버의RAID정 책을 설정 해야 합니 다.
24
페이 지의
"
멤버
RAID
정책
설정
"으로이동합니다.
다음보 기는 배열 을초 기화 하고 그룹을생성하기위한 setup(설치 )유 틸리 티이 용방 법에 대해나
타내고있습니다.
보 기 - 설 치 유 틸 리 티 이 용 방 법
Login: grpadmin
Password: xxxxxxxx
설치 유틸리 티는 스토 리지 배열에 대한 초기 네트워크와 스토 리지 구성 을 지정한 다음, 배열을
멤버로 또는 배열의 새로 운 그룹이 나 기존 그룹으로 구성합니 다.
도움이 필요 한 경우, 명령 프롬 프트에 서 물음표 (?)를 입력합니다.
그룹 관리자 시작
Copyright 2013 Dell Inc.
It appears that the storage array has not been configured.
Would you like to configure the array now? (y/n) [n] y
Group Manager Setup Utility
Do you want to proceed (yes | no) [no]? yes
Initializing. This may take several minutes to complete.
Enter the network configuration for the array:
Member name []: member1
Network interface [eth0]: eth0
IP address for network interface []: 192.17.2.41
Netmask [255.255.255.0]:
Default gateway [192.17.2.1]:
Enter the name and IP address of the group that the array will join.
Group name []: group1
Group IP address []: 192.17.2.20
Searching to see if the group exists. This may take a few minutes.
The group does not exist or currently cannot be reached. Make sure you have entered the correct
group IP address and group name.
Do you want to create a new group (yes | no) [yes]? yes
그룹 구성
Group Name: group1
Group IP address []: 192.17.2.20
Do you want to use the group settings shown above (yes | no) [yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
22