Setup Guide
Table Of Contents
- Preface
- Introduction to PS Series Storage Arrays
- Steps for Setting Up and Using an Array
- Step 1. Set Up the Array Hardware
- Step 2. Configure the Array and Create a Group
- Step 3. Set the RAID Policy
- Step 4. Create a Volume
- Step 5. Connect to the Volume from a Host System
- Advanced Operations and More Information
- Index
PS Series 3000 QuickStart Step 4. Create a Volume
28
Click Next to display the Create Volume – Summary dialog box. If the volume
configuration is satisfactory, click
Finish to create the volume.
Create Volume – Summary
Once you create a volume, you can create snapshots of the volume or perform
other tasks. The following window shows a group with volumes and snapshots.
Group Summary – With Volumes