Owners Manual
Table Of Contents
- Preface
- 1 Basic Array Information
- 2 Maintaining Disks
- 3 Maintaining Control Modules
- Supported Control Modules
- Interpreting Control Module LEDs
- Control Module Handling Requirements
- Identifying Control Module Failures
- Understanding Failover Behavior
- Maintaining Control Module Firmware
- Connecting Network Cables
- Removing a Control Module
- Installing a Control Module
- Replacing the Compact Flash Card
- 4 Maintaining Power Supply and Cooling Modules
- A Environmental, Power, and Other Specifications
- Index
PS3000 Series Hardware Maintenance Maintaining Disks
2–6
Figure 2-4 shows how to install a disk in an array. Use the same instructions for
installing a blank carrier.
Notes: Make sure the disk is oriented in the position shown below, with the
handle release button to the left.
When correctly installed, a disk will be level with the front of the array. If
the disk is protruding from the array, reinstall the disk.
Figure 2-4: Installing a Disk
Verify that the new disk is operational by checking the LEDs on the front panel, as
described in Interpreting Disk LEDs on page 2-1. The top LED should be green or
flashing green, and the bottom LED should be off.
In addition, the GUI Member Disks window and the CLI
member select show
disks
command output should show that the new disk is operational.