Owner's Manual

Overview 11
Steps to Upgrade
To upgrade to the new version:
1
Double-click the
Dell_EqualLogic_Storage_Management_Pack_Suite_v4.1.msi file to
launch the installer. The following message is displayed:
Another
version of the product is already installed. Would
you like to upgrade?
2
Click Yes , and then click Next on the Welcome screen.
3 Accept the license agreement and click Next .
4 Follow the instructions on the wizard to install the Dell EqualLogic
Management Pack and click
Finish on the wizard after the installation is
complete.
5 Launch the Operations Console and navigate to the Administration tab
to import the new management pack. For more information on importing
the management pack, see Importing the Management Pack.
NOTE: When you upgrade from version 4.0 to version 4.1, components that are in
critical or warning state, may display a normal state after upgrading. The
components display the correct health status only from the subsequent monitoring
cycle. The critical or warning health is reflected only after 62 minutes when the first
monitoring cycle triggers. This is applicable only to SCOM 2007 SP1, SCE 2007 SP1,
SCOM 2007 R2, and SCE 2010.
NOTE: After you upgrade to version 4.1, you may see some of the components in
Diagram view still displaying the icons from the earlier version. To see the new
icons, restart the Operations Console using the /clearcache option.
EQL-QIG.book Page 11 Wednesday, September 21, 2011 2:13 PM