Owner's Manual

26 Dell EqualLogic Storage Management Pack Suite Operations
Customizing the EqualLogic Storage Management
Pack
Unit Monitors
You can customize the following parameters of the EqualLogic Management
Pack unit monitors by using overrides:
• Enabled : Allows you to enable or disable monitors. You can choose the
Override Setting to be True or False. The default setting is True.
• Interval in Seconds : The frequency (in seconds) with which the
Management Pack polls the Dell device to check the health of a
component. The default setting for monitors could range between
3600 - 4300 seconds.
NOTE: All the unit monitors are triggered by a periodic poll configured as
IntervalSeconds.
Table 3-2. Dell Monitors -EqualLogic Storage Arrays
Group Name Unit Monitor Name Description Default
Periodic Poll
Setting
Dell EqualLogic
Member
Dell EqualLogic
Member Status
(Periodic)
Unit Monitor for all
EqualLogic members:
Tracks the global health
status of the EqualLogic
member.
3600 seconds
(60 minutes)
Dell EqualLogic
Member
Controller
Dell EqualLogic
Controller Status
(Periodic)
Unit Monitor for
EqualLogic Controllers:
Indicates the health of the
Controllers.
3700 seconds
(63 minutes)
Dell EqualLogic
Member Disk
Dell EqualLogic
Physical Disk
Status (Periodic)
Unit Monitor for
EqualLogic Physical Disks:
Indicates the health of the
storage array’s physical
disks.
4320 seconds
(62 minutes)
A5_bk0.book Page 26 Wednesday, April 14, 2010 5:14 PM