Owners Manual

2. Connect the power cord to the power supply, then connect the other end to the power source.

3. Secure the cord with the strain relief strap.

4. Make sure the power supply LED illuminates.

Figure 10: Installing a Power Supply

When installing a new power supply, allow several seconds for the system to recognize the power supply

and determine its status. The power-supply status indicator turns green to signify that the power supply is

functioning properly (see Table 5).

Removing the Bezel

If you need to access fans, or remove the bezel for any other reason, see Figure 11 and follow these steps:

1. Use the key to unlock the bezel, if it is locked (callout 1).

2. Push up on the release latch on the left side of the bezel and carefully pull out the bezel from the left side of

the chassis (callout 1).

3. Move the bezel to the left to disengage it from the right side of the chassis (callouts 2 and 3).

Dell EqualLogic FS7600 Hardware Owner's Manual 2 Replacing Components