Administrator Guide

Configuring telemetry
Document 418
2 Configuring telemetry
Telemetry configuration allows you to configure telemetry data streaming behavior and report generation
behavior. It includes the global settings common to all reports, and those settings specific to each available
report. Enabling or disabling telemetry at the global setting level enables or disables all reports for telemetry
streaming. By default, the telemetry feature is disabled at the global setting level and for all reports
individually. A simple configuration includes enabling telemetry at the global setting, each wanted report, and
the report interval for each report.
By default, telemetry reports are sent to connected Redfish clients using the HTTP protocol. To receive
reports using the syslog protocol, configure the Remote Syslog (RSyslog) settings. Typically, reports are
streamed on a configured ReportInterval condition, but they can also be streamed at error or warning
conditions. Trigger definitions are based on iDRAC life-cycle events that are generated for error and warning
conditions.
Global settings
Setting
EnableTelemetry
RsyslogServer1
RsyslogServer1Port
RsyslogServer2
RsyslogServer2Port
TelemetrySubscription1
TelemetrySubscription2
Per report settings
Setting
EnableTelemetry
ReportInterval
ReportTriggers
RsyslogTarget
DevicePollFrequency
* read-only
Supported reports
AggregationMetrics
CUPS
GPUMetrics
NICStatistics
PSUMetrics
ThermalMetrics
CPUMemMetrics
FanSensor
GPUStatistics
NVMeSMARTData
Sensor
ThermalSensor
CPURegisters
FCSensor
MemorySensor