White Papers

Version 1.0.0 13
Table 7 – DCIM_NICEnumeration Attributes
AttributeName
Description
PossibleValues
TcpIpViaDHCP
Acquiring TCP/IP configuration via DHCP for iSCSI.
“Disabled”, “Enabled”
IscsiViaDHCP
Acquire iSCSI parameters via DHCP.
“Disabled”, “Enabled”
ChapAuthEnable
Enable/Disable CHAP authentication for iSCSI.
“Disabled”, “Enabled”
IscsiTgtBoot
Enable/Disable booting to iSCSI target after logon.
“Disabled”, “Enabled”, “One
Time Disabled”
TcpTimestmp
Enable/Disable TCP timestamp for iSCSI.
“Disabled”, “Enabled”
FirstHddTarget
Enable/Disable target appears as first hard disk drive (HDD) in the system
for iSCSI.
“Disabled”, “Enabled”
IpVer
IP version support. Modifying this parameter will reset all IP-related fields
for iSCSI.
“IPv4”, “IPv6”
ConnectFirstTgt
Enable/Disable first target establishment for iSCSI.
“Disabled”, “Enabled”
ConnectSecondTgt
Enable/Disable second target establishment for iSCSI.
“Disabled”, “Enabled”
LegacyBootProto
Select non-UEFI Boot Protocol: Preboot Execution Environment
(PXE)/iSCSI/NONE for Managed Boot Agent.
“PXE”, “iSCSI”, “NONE”
LnkSpeed
Configure link speed for Managed Boot Agent.
“AutoNeg”, “10Mbps Half”,
“10Mbps Full”, “100Mbps
Half”. “100Mbps Full”
WakeOnLan
Configure preboot Wake on LAN (WOL) for Managed Boot Agent..
“Disabled”, “Enabled”
VLanMode
Configure virtual LAN mode for Managed Boot Agent.
“Disabled”, “Enabled”
BootRetryCnt
Number of boot retries for Managed Boot Agent.
“No Retry”, “1 Retry”, “2
Retries”, “3 Retries”, “4
Retries”, “5 Retries”, “6
Retries”, “Indefinite Retries”
UseIndTgtPortal
Use independent target portal when multipath I/O is enabled.
“Disabled”, “Enabled”
UseIndTgtName
Use independent target name when multipath I/O is enabled.
“Disabled”, “Enabled”
7.3 DCIM_NICString
This section describes the implementation for the DCIM_NICString class.
Each DCIM_NICString instance is logically associated to a DCIM_NICView instance, where the
DCIM_NICString. FQDD property is equal to the FQDD property on the DCIM_NICView instance.
This class shall be instantiated in the Implementation Namespace.
7.3.1 WBEM URIs for WinRM
®
The class WBEM URI shall be “http://schemas.dell.com/wbem/wscim/1/cim-
schema/2/DCIM_NICString?__cimnamespace=<Implementation Namespace>”
The key property shall be the InstanceID.
The instance WBEM URI for DCIM_NICString instance shall be:
“http://schemas.dell.com/wbem/wscim/1/cim-
schema/2/DCIM_NICString?__cimnamespace=<Implementation Namespace>+InstanceID= <FQDD>”