Deployment Guide
Table Of Contents
- 1 Introduction
- 2 Hardware overview
- 3 Leaf-spine overview
- 4 Protocols used in the leaf-spine examples
- 5 Layer 3 configuration planning
- 6 Example 1: Layer 3 with Dell EMC leaf and spine switches using OSPF
- 7 Example 2: Layer 3 with Dell EMC leaf and spine switches using eBGP
- A Dell EMC Networking ONIE switch factory default settings
- B Validated hardware and operating systems
- C Technical support and resources
- D Support and Feedback
23 Dell EMC Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10 | Version 1.0
Internal Use - Confidential
6.3 Example 1 validation
In addition to sending traffic between hosts, the configuration shown in Figure 12 can be validated with the
commands shown in this section. For more information on commands and output, see the Command Line
Reference Guide for the applicable switch (links to documentation are provided in Appendix C).
Command and output examples are provided for one spine and one leaf switch. Command output on other
switches is similar.
6.3.1 show ip ospf neighbor
This command shows the state of all connected OSPF neighbors. In this configuration, each spine has four
neighbors (the four leaf switches) and each leaf switch has two neighbors (the two spine switches).
Z9100-Spine1#show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface Area
--------------------------------------------------------------------------------
10.0.2.1 1 FULL/DR 00:00:30 192.168.1.1 ethernet1/1/1 0.0.0.0
10.0.2.2 1 FULL/DR 00:00:33 192.168.1.3 ethernet1/1/2 0.0.0.0
10.0.2.3 1 FULL/DR 00:00:36 192.168.1.5 ethernet1/1/3 0.0.0.0
10.0.2.4 1 FULL/DR 00:00:39 192.168.1.7 ethernet1/1/4 0.0.0.0
S4148F-Leaf1#show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface Area
--------------------------------------------------------------------------------
10.0.1.1 1 FULL/BDR 00:00:30 192.168.1.0 ethernet1/1/25 0.0.0.0
10.0.1.2 1 FULL/BDR 00:00:33 192.168.2.0 ethernet1/1/26 0.0.0.0