Users Guide

Full Disk Encryption v2.8
● No technical advisories exist.
BitLocker Manager v2.8
● No technical advisories exist.
New Features and Functionality v2.7
● Windows 10 v2004 (May 2020 Update/20H1) does not support 32-bit architecture. For more information, see https://
docs.microsoft.com/windows-hardware/design/minimum/minimum-hardware-requirements-overview.
● Endpoint Security Suite Enterprise is now supported with Windows 10 v2004 (May 2020 Update/20H1).
● Advanced Threat Prevention is now supported with Windows 10 v2004 (May 2020 Update/20H1).
● Firewall and Web Protection is now supported with Windows 10 v2004 (May 2020 Update/20H1).
● Advanced Threat Prevention v2.0.1241.1 has been integrated into Endpoint Security Suite Enterprise v2.7.
● Firewall and Web Protection v10.7.0.812.4 has been integrated into Endpoint Security Suite Enterprise v2.7. This version
contains fixes for CVE-2020-7250, CVE-2020-7255, CVE-2020-7257 and others. For more information, see https://
kc.mcafee.com/corporate/index?page=content&id=SB10309.
● Firewall and Web Protection now requires the following Command-line installation syntax:
○ \Threat Protection\EndPointSecurity
The following example installs the Firewall and Web Protection with default parameters (silent mode, install Client
Firewall, and Web Protection, override the Host Intrusion Prevention, no content update, no settings saved with logs in
C:\ProgramData\Dell\Dell Data Protection).
".\Threat Protection\EndPointSecurity\EPsetup.exe" ADDLOCAL="fw,wc" /override"hips" /
nocontentupdate /qb! /L*v"C:\ProgramData\Dell\Dell Data Protection\Installer Logs\"
Then:
\Threat Protection\ThreatProtection\WinXXR
○ The following example installs the client with default parameters (suppress the reboot, no dialogue, no progress bar, no
entry in the Control Panel Programs list).
"Threat Protection\ThreatProtection\WinXXR\DellThreatProtection.msi" /qn
REBOOT=ReallySuppress ARPSYSTEMCOMPONENT=1
Then:
\Threat Protection\SDK
○ The following command line loads the certificate default parameters.
"Threat Protection\SDK\EnsMgmtSdkInstaller.exe" -LoadCert >"C:\ProgramData\Dell\Dell
Data Protection\Installer Logs\McAfeeSDKInstallerBeforeEndPoint.log"
Then:
\Threat Protection\SDK
○ The following example installs the SDK.
"Threat Protection\SDK\EnsMgmtSDKInstaller.exe" -InstallSDK -RemoveRightClick -
RemoveMcTray >> "<OUTPUTDIRECTORY>\McAfeeSDKInstallerAfterEndPoint.log"
● The Dell DiagnosticInfo utility now collects diagnostic and logging information for Firewall and Web Protection to assist with
troubleshooting and diagnostics.
● The Dell DiagnosticInfo utility logging is improved.
● Boot order logging is improved.
● A new RAID controller driver is added to the Dell Encryption Recovery WinPE environment. This enables recovery of disks in
newer platforms configured in RAID ON mode.
● Dell Encryption performs a re-analysis of encrypted volumes on key backups to ensure policy is correctly applied to the entire
drive. This will appear as a re-sweep of encryption of the disk, which may lead to a temporary increase in system resource
use.
Technical Advisories
13