Install Guide
Table Of Contents
- Dell Endpoint Security Suite Enterprise Advanced Installation Guide v3.1
- Contents
- Introduction
- Requirements
- Registry Settings
- Install Using the Master Installer
- Uninstall the Master Installer
- Install Using the Child Installers
- Uninstall Using the Child Installers
- Data Security Uninstaller
- Commonly Used Scenarios
- Provision a Tenant
- Configure Advanced Threat Prevention Agent Auto Update
- Pre-Installation Configuration for SED UEFI, and BitLocker Manager
- Designate the Dell Server through Registry
- Extract Child Installers
- Configure Key Server
- Use the Administrative Download Utility (CMGAd)
- Configure Encryption on a Server Operating System
- Configure Deferred Activation
- Troubleshooting
- Glossary
Introduction
This guide details how to install and configure Advanced Threat Prevention, Encryption, SED management, Full Disk Encryption,
Web Protection and Client Firewall, and BitLocker Manager.
All policy information and their descriptions are found in the AdminHelp.
Before You Begin
1. Install the Dell Server before deploying clients. Locate the correct guide as shown below, follow the instructions, and then
return to this guide.
● Security Management Server Installation and Migration Guide
● Security Management Server Virtual Quick Start Guide and Installation Guide
● Verify that polices are set as desired. Browse through the AdminHelp, available from the ? at the top right of the screen.
AdminHelp is page-level help designed to help you set and modify policy and understand your options with your Dell
Server.
2. Provision a Tenant for Advanced Threat Prevention. A tenant must be provisioned in the Dell Server before Advanced Threat
Prevention enforcement of policies becomes active.
3. Thoroughly read the Requirements chapter of this document.
4. Deploy clients to users.
1
6 Introduction