Install Guide
Table Of Contents
- Dell Endpoint Security Suite Enterprise Advanced Installation Guide v3.1
- Contents
- Introduction
- Requirements
- Registry Settings
- Install Using the Master Installer
- Uninstall the Master Installer
- Install Using the Child Installers
- Uninstall Using the Child Installers
- Data Security Uninstaller
- Commonly Used Scenarios
- Provision a Tenant
- Configure Advanced Threat Prevention Agent Auto Update
- Pre-Installation Configuration for SED UEFI, and BitLocker Manager
- Designate the Dell Server through Registry
- Extract Child Installers
- Configure Key Server
- Use the Administrative Download Utility (CMGAd)
- Configure Encryption on a Server Operating System
- Configure Deferred Activation
- Troubleshooting
- Glossary
Installation is complete.
13. Restart the computer. Dell recommends snoozing the reboot only if time is needed to save your work and close applications.
Encryption cannot begin until the computer has rebooted.
Install Using the Command Line
Locate the installer in C:\extracted\Encryption
● Use DDPE_xxbit_setup.exe to install or upgrade using a scripted installation, using batch files, or any other push
technology available to your organization.
Switches
The following table details the switches available for the installation.
Switch
Meaning
/v Pass variables to the .msi inside the DDPE_XXbit_setup.exe
/a Administrative installation
/s Silent mode
Parameters
The following table details the parameters available for the installation.
Component
Log File Command Line Parameters
All /l*v [fullpath][filename].log * SERVERHOSTNAME=<Security Management Server Name>
SERVERMODE=1
POLICYPROXYHOSTNAME=<RGK Name>
52 Install Using the Child Installers