Install Guide
Table Of Contents
- Dell Endpoint Security Suite Enterprise Advanced Installation Guide v3.0
- Contents
- Introduction
- Requirements
- Registry Settings
- Install Using the Master Installer
- Uninstall the Master Installer
- Install Using the Child Installers
- Uninstall Using the Child Installers
- Data Security Uninstaller
- Commonly Used Scenarios
- Provision a Tenant
- Configure Advanced Threat Prevention Agent Auto Update
- Pre-Installation Configuration for SED UEFI, and BitLocker Manager
- Designate the Dell Server through Registry
- Extract Child Installers
- Configure Key Server
- Use the Administrative Download Utility (CMGAd)
- Configure Encryption on a Server Operating System
- Configure Deferred Activation
- Troubleshooting
- Glossary
Pre-Installation Configuration for SED UEFI,
and BitLocker Manager
Initialize the TPM
● You must be a member of the local administrators group, or equivalent.
● The computer must be equipped with a compatible BIOS and a TPM.
● Follow the instructions located at http://technet.microsoft.com/en-us/library/cc753140.aspx.
Pre-Installation Configuration for UEFI Computers
Enable Network Connectivity During UEFI Pre-boot Authentication
For pre-boot authentication to succeed on a computer with UEFI firmware, the PBA must have network connectivity. By
default, computers with UEFI firmware do not have network connectivity until the operating system is loaded, which occurs
after PBA mode.
The following procedure enables network connectivity during PBA for UEFI-enabled computers. Because the configuration steps
vary from one UEFI computer model to the next, the following procedure is only an example.
1. Boot into the UEFI firmware configuration.
2. Press F2 continuously during boot until you see a message in the upper right screen similar to "preparing one-time boot
menu."
3. Enter the BIOS administrator password, if prompted.
NOTE:
Typically, you will not see this prompt if this is a new computer since the BIOS password has not yet been configured.
4. Select System Configuration.
5. Select Integrated NIC.
6. Select the Enable UEFI Network Stack check box.
7. Select either Enabled or Enabled w/PXE.
8. Select Apply
NOTE:
Computers without UEFI firmware do not require configuration.
12
82 Pre-Installation Configuration for SED UEFI, and BitLocker Manager