Install Guide
Table Of Contents
- Dell Endpoint Security Suite Enterprise Advanced Installation Guide v3.0
- Contents
- Introduction
- Requirements
- Registry Settings
- Install Using the Master Installer
- Uninstall the Master Installer
- Install Using the Child Installers
- Uninstall Using the Child Installers
- Data Security Uninstaller
- Commonly Used Scenarios
- Provision a Tenant
- Configure Advanced Threat Prevention Agent Auto Update
- Pre-Installation Configuration for SED UEFI, and BitLocker Manager
- Designate the Dell Server through Registry
- Extract Child Installers
- Configure Key Server
- Use the Administrative Download Utility (CMGAd)
- Configure Encryption on a Server Operating System
- Configure Deferred Activation
- Troubleshooting
- Glossary
Uninstall Web Protection and Firewall
If Web Protection and Firewall are not installed, proceed to Uninstall Encryption Client.
Command Line Uninstallation
● Once extracted from the Endpoint Security Suite Enterprise master installer, the
Web Protection and Firewall client installer can be located at C:\extracted\Threat
Protection\ThreatProtection\WinXXR\DellThreatProtection.msi.
● Go to Add/Remove Programs in the Control Panel and uninstall the following components in this order.
○ McAfee Endpoint Security Firewall
○ McAfee Endpoint Security Web Control
○ McAfee Agent
● Then:
● The following example uninstalls Web Protection and Firewall .
MSIEXEC.EXE /x "DellThreatProtection.msi"
Uninstall Advanced Threat Prevention
Command Line Uninstallation
● The following example uninstalls the Advanced Threat Prevention client.
This command must be run from an
administrative command prompt.
wmic path win32_product WHERE (CAPTION LIKE "%%CYLANCE%%") call uninstall
Shut down and restart the computer, then uninstall the Dell Encryption Management Agent component.
●
NOTE:
If you installed the SED client or activated pre-boot authentication, follow the uninstallation instructions in
Uninstall SED Client.
The following example uninstalls only the Dell Encryption Management Agent component and not the SED client.
EMAgent_XXbit_setup.exe /x /s /v" /qn"
Uninstall Full Disk Encryption
● Network connection to the Dell Server is required for PBA deactivation.
Process
● Deactivate the PBA, which removes all PBA data from the computer and unlocks the Full Disk Encryption keys.
● Uninstall Full Disk Encryption.
Deactivate the PBA
1. As a Dell administrator, log in to the Management Console.
2. In the left pane, click Populations > Endpoints.
3. Select the appropriate Endpoint Type.
4. Select Show >Visible, Hidden, or All.
5. If you know the Hostname of the computer, enter it in the Hostname field (wildcards are supported). You may leave the field
blank to display all computers. Click Search.
Uninstall Using the Child Installers
63