Owners Manual

Removing the microSD card

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

Steps

1 Locate the microSD card slot on the IDSDM module, and press the card to partially release it from the slot. To locate the IDSDM

module, see System board jumpers and connectors.

2 Hold the microSD card and remove it from the slot.

NOTE: Temporarily label each microSD card with its corresponding slot number after removal.

Next steps

1 Follow the procedure listed in After working inside your system.

2 Install a microSD card.

Installing the microSD card

Prerequisites

Follow the safety guidelines listed in Safety instructions.

NOTE

: To use a microSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.

NOTE: If reinstalling, ensure that you install the microSD cards into the same slots based on the labels you had marked on the

cards during removal.

Steps

1 Locate the microSD card connector on the IDSDM. Orient the microSD card appropriately and insert the contact-pin end of the card

into the slot. To locate the IDSDM, see System board jumpers and connectors.

NOTE

: The slot is keyed to ensure correct insertion of the card.

2 Press the card into the card slot to lock it into place.

Next step

Follow the procedure listed in After working inside your system.

Removing the optional IDSDM

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 If you are replacing the IDSDM card, remove the microSD cards.

NOTE

: Temporarily label each microSD card with its corresponding slot number after removal.

Steps

1 Locate the IDSDM connector on the system board.

Installing and removing system components