Owners Manual

Steps

1 Connect the SAS cables to the card.

NOTE: Ensure that you use the labels on the cable to connect the cables to the correct connectors. The cable does not

function properly if reversed.

2 Hold the storage controller card by its edges, and align the connector on the card with the connector on the system board.

3 Lower the card into the system until the card is rmly seated.

4 Route the SAS cable through the channel on the inner side of the chassis.

5 Connect the SAS cables from the storage controller card to the connectors on hard drive backplane.

6 Close the riser retention bracket and slide the bracket to lock the storage controller card.

Figure 47. Installing the storage controller card

Next steps

1 Install the NDC riser.

2 Follow the procedure listed in After working inside your system.

IDSDM

The following section describes the process of removing and installing the micro SD card and IDSDM card:

Installing and removing system components