Owners Manual

Removing the storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the Network Daughter Card (NDC) riser.
Steps
1 Slide the riser retention bracket to unlock the storage controller card.
2 Hold the storage controller card by its edges and lift to remove it from the connector on the system board.
3 Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
Figure 46. Removing the storage controller card
Next step
1 Install the storage controller card.
Installing the storage controller card
Prerequisite
Follow the safety guidelines listed in Safety instructions.
88
Installing and removing system components