Owners Manual
Next step
1 Install the NDC riser.
Installing the NDC riser
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Hold the Network Daughter Card (NDC) riser by its edges and align the connector on the NDC riser and guide pin on the system
board.
2 Insert the NDC riser until the card is fully seated.
3 Close the riser retention bracket and slide the bracket to lock the NDC riser.
Figure 45. Install the NDC riser
Next steps
1 Connect the cables to the NDC riser.
2 Follow the procedure listed in After working inside your system.
Storage controller card
The storage controller card is installed on the expansion card slot on the system board, which provides the integrated storage subsystem
for your system’s internal hard drives. The controller supports SAS and SATA hard drives and also enables you to set up the hard drives in
RAID congurations as supported by the version of the storage controller included with your system.
Installing and removing system components
87