Owners Manual

Steps

1 Align the pin 1 indicator of the heat sink to the system board and then place the processor and heat sink module (PHM) on the

processor socket.

CAUTION: To avoid damaging the ns on the heat sink, do not press down on the heat sink

ns.

NOTE: Ensure that the PHM is held parallel to the system board to prevent damaging the components.

2 Push the blue retention clips inward to allow the heat sink to drop into place.

3 Using the #Torx T30 screwdriver, tighten one screw at a time.

NOTE: Ensure that the screw is tightened completely before moving onto the next screw.

NOTE: The processor and heat sink module retention screws should not be tightened to more than 0.13 kgf-m (1.35 N.m or

12 in-lbf).

Figure 46. Installing the processor and heat sink module (2U)

Figure 47. Installing a processor and heat sink module (1U)

Installing and removing system components