Owners Manual

M.2 SSD module

Removing the M.2 SSD module

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Remove the air shroud.

4. Remove the BOSS card.

NOTE:

Removing the BOSS card is similar to the procedure for removing an expansion card riser.

Steps

1. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.

2. Pull the M.2 SSD module away from the BOSS card.

Figure 69. Removing the M.2 SSD module

a. module connector (2)

b. screws (2)

c. module (2)

Next steps

Install the M.2 SSD module.

Installing the M.2 SSD module

Prerequisites

1. Follow the safety guidelines listed in Safety instructions .

Steps

1. Align the M.2 SSD module connectors with the connectors on the BOSS card.

2. Push the M.2 SSD module until the module is seated firmly on the BOSS card.

Installing and removing system components