Owners Manual

Figure 67. Removing filler bracket for low profile riser

3. Hold the card by its edges, and align the card edge connector with the expansion card connector on the riser.

4. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.

5. Close the expansion card retention latch.

Figure 68. Installing expansion card into low profile riser

Next steps

1. If applicable, connect the cables to the expansion card.

2. Install the expansion card riser.

3. If applicable, install air shroud.

4. Follow the procedure listed in After working inside your system.

5. Install any device drivers required for the card as described in the documentation for the card.

Installing and removing system components