Owners Manual

Removing the expansion card from the expansion card
riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If applicable, remove the air shroud.
4. Remove the expansion card riser.
5. If applicable, disconnect the cables from the expansion card.
Steps
1. Lift the expansion card latch out of the slot on the riser (Low profile expansion riser 1) .
2. Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
Figure 65. Removing expansion card from low profile riser
3. If the expansion card is not going to be replaced, install a filler bracket.
96
Installing and removing system components