Owners Manual

3. Lift the plunger to lock the riser in place.

Next steps

1. Close the cable guiding latch.

2. Follow the procedure listed in After working inside your system.

Expansion cards and expansion card risers

NOTE: A System Event Log (SEL) event is logged if an expansion card riser is not supported or missing. It does not

prevent your system from turning on. However, if a F1/F2 pause occurs with an error message, see

Troubleshooting

expansion cards

section in the

Dell EMC PowerEdge Servers Troubleshooting Guide

at www.dell.com/

poweredgemanuals.

Removing an expansion card riser

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Replace the internal MiniPERC riser (applicable to expansion card riser 2).

Steps

Hold the touch points, and lift the expansion card riser.

Figure 61. Removing low profile riser right

Installing and removing system components