Owners Manual

Figure 50. Removing a processor and heat sink module (1U)

Next steps

Install the Processor and Heat sink module.

Removing processor from the processor and heat sink

module

Prerequisites

NOTE:

Only remove the processor from the processor and heat sink module if you are replacing the processor or heat

sink. This procedure is not required when replacing a system board.

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Remove the air shroud.

4. Remove a processor and heat sink module.

Steps

1. Place the heat sink with the processor side facing up.

2. Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal

paste seal.

3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.

Installing and removing system components