Owners Manual

Figure 44. Removing the drive from the drive carrier

2. Lift the drive out of the drive carrier.

Next steps

If applicable, install the drive into the drive carrier.

Installing a drive into the drive carrier

Prerequisites

Follow the safety guidelines listed in Safety instructions.

CAUTION:

Mixing drive carriers from other generations of XC XR2 servers is not supported.

NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.

Steps

1. Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.

2. Align the screw holes on the drive with the screws holes on the drive carrier.

When aligned correctly, the back of the drive is flush with the back of the drive carrier.

Installing and removing system components