Owners Manual

Figure 37. Installing the Smart Card Reader bracket

Next steps

1. Reconnect all cables to the Smart Card Reader.

NOTE:

Ensure that the cables inside the system are routed along the chassis wall and secured using the cable

securing bracket.

2. Follow the procedure listed in After working inside your system.

Intrusion switch

Removing the intrusion switch

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

NOTE:

Ensure that you note the routing of the cables as you remove them from the system board. You must route

the cables properly when you replace them to prevent the cables from being pinched or crimped.

3. Remove the air shroud.

4. Remove internal MiniPERC riser.

Steps

1. Disconnect the intrusion switch cable connected to the system board.

2. Slide the intrusion switch out of the intrusion switch slot.

Installing and removing system components