Owners Manual

Figure 25. Removing the system cover

Next steps

Follow the procedure listed in After working inside your system.

Installing the system cover

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.

Steps

1. Align the tabs on the system cover with the guide slots on the system.

2. Close the system cover latch.

The system cover slides forward, the tabs on the system cover engage with the guide slots on the system and the system cover latch

locks into place.

3. Tighten the thumb screw that secures the system cover to the back of the system.

4. Tighten the captive screws on the top of the system cover.

NOTE:

Follow the sequence provided on the system cover to tighten the screws.

5. Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock clockwise to the locked position.

Installing and removing system components