Owners Manual

Figure 24. Installing the bezel guard

Next steps

1. Install the front bezel.

2. Follow the procedure listed in After working inside your system

System cover

Removing the system cover

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

Steps

1. Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.

2. Loosen the two captive screws on the top of the system cover.

3. Loosen the thumb screw that secures the back of the system cover to the chassis.

NOTE:

Ensure that the three screws are loosened before lifting the latch to avoid damage to the system cover.

4. Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.

5. Hold the cover on both sides, and lift the cover away from the system.

Installing and removing system components