Owners Manual

Back view of the system
The back view of the system displays the features available on the back of the system.
Figure 7. Back view of the system
Table 8. Back panel features of XC XR2
Item Features Icon Description
1 Serial port Use the serial port to connect a serial device to the system. For
more information about the supported serial port, see the Technical
specifications section.
2 iDRAC9 Enterprise port
Use the iDRAC9 dedicated network port to securely access the
embedded iDRAC on a separate management network, see the
Integrated Dell Remote Access Controller User's Guide at
www.dell.com/idracmanuals.
3 Ethernet ports (2) Use the Ethernet ports to connect Local Area Networks (LANs) to
the system. For more information about the supported Ethernet
ports, see the Technical specifications section.
4 Low profile riser right slot N/A Use the card slot to connect half-height PCIe expansion card on
low profile riser.
5 Low profile riser left slot N/A Use the card slot to connect half-height PCIe expansion card on
low profile riser.
6 Power supply unit (PSU) N/A For more information about the PSU configurations, see the
Technical specifications section.
7 Power supply unit (PSU) N/A For more information about the PSU configurations, see the
Technical specifications section.
8 LOM riser slot N/A Use the LOM riser slot to connect additional NIC.
9 USB 3.0 port (2) Use the USB 3.0 port to connect USB devices to the system.
These ports are 4-pin, USB 3.0-compliant.
10 VGA port Use the VGA port to connect a display to the system. For more
information about the supported VGA port, see the Technical
specifications section.
11 System status indicator cable
port
N/A Enables you to connect the status indicator cable and view system
status when the CMA is installed.
12 System identification button Press the system ID button:
• To locate a particular system within a rack.
• To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE:
Dell EMC XC XR2 overview 13