Owners Manual

Figure 99. Installing the 901D riser on the system board
NOTE:
The 901D kit includes additional mylar foam. Place the mylar foam between the risers and the chassis as
required, to provide maximum support.
9. Turn over the system cover and locate the screw hole. The screw hole is covered by a label. Use a plastic scribe to puncture the label
and SIL, to expose the screw hole. This screw hole secures the system cover, and the 901D riser.
Figure 100. Exposing the standoff hex spacer screw hole
10. Installing the system cover.
NOTE:
Ensure to align the system cover with the 901D kit standoff hex spacers.
11. Fasten the system cover with the screws shipped in the 901D kit.
128
Installing and removing system components