Owners Manual

Installing the system board
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Unpack the new system board assembly.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.
2. Holding the system board holder, align the connectors on the system board with the slots on the back of the chassis and insert the
system board at an angle to avoid the fan shroud post.
3. Routing the VGA cable as close as possible to the internal chassis wall, connect the cable to the system board connector.
4. Align the slot on the riser 2 support clip with the standoff on the internal chassis wall.
5. Push the Riser 2 support clip at an angle so that the standoff locks into the side of the support clip.
NOTE:
Ensure that the cable is not pinched.
6. Using a Phillips #2 screwdriver, tighten the screws to secure the system board to the chassis.
Figure 91. Installing the system board
Next steps
1. Replace the following:
a. Install the Trusted Platform Module (TPM).
NOTE:
The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM
plug-in module is provided for all system board replacements, where a TPM plug-in module was installed.
b. Internal PERC riser
c. Internal USB key (if applicable)
d. Connect the IO cable to internal USB port
e. IDSDM/vFlash module card
120
Installing and removing system components