Owners Manual

Figure 89. Installing the right control panel
Next steps
1. Install the MiniPERC riser
2. Install the hard drive backplane.
3. Install the cooling fan.
4. Follow the procedure listed in After working inside your system.
System board
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create
a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your hard drives.
CAUTION: Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in module is
installed, it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in
module breaks the cryptographic binding, and it cannot be re-installed or installed on another system board.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the following:
a. Air shroud
b. Expansion cards and expansion card risers
c. Internal PERC riser
d. IDSDM or vFlash module
e. Internal USB memory key (if installed)
118
Installing and removing system components