Owners Manual

Figure 88. Removing the right control panel
2. Using a Phillips #1 screwdriver, remove the screw that secures the right control panel to the system.
Next steps
1. Install the right control panel.
Installing the right control panel
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Route the control panel cable through the slot on the system.
2. Align the right control panel with the control panel slot on the system and attach the control panel to the system.
3. Connect the control panel cable to the system board connector and secure it using cable latch.
4. Using Phillips #1 screwdriver, replace the screw that secures the right control panel to the system.
Installing and removing system components
117