Owners Manual
Figure 87. Installing the left control panel
Next steps
1. Install the air shroud.
2. Install the MiniPERC riser.
3. Follow the procedure listed in After working inside your system.
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route
the cables properly when you replace them to prevent the cables from being pinched or crimped.
3. Remove cooling fan.
4. Remove internal MiniPERC riser.
5. Remove hard drive backplane.
Steps
1. Lift the cable latch and disconnect the control panel cable from the system board connector.
116
Installing and removing system components