Owners Manual

Steps
1. Slide the PIB into place.
2. Using a Phillips #2 screwdriver, tighten the two screws to secure the PIB to the system.
3. Route the cables and connect it to the appropriate connectors on the power interposer board, system board, and hard-drive
backplane.
Figure 85. Installing a PIB
Next steps
1. Install PSUs.
2. Install the MiniPERC riser.
3. Install the cooling fans.
4. Install the air shroud.
5. Follow the procedure listed in After working inside your system.
Control panel
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route
the cables properly when you replace them to prevent the cables from being pinched or crimped.
3. Remove the internal MiniPERC riser.
Steps
1. Disconnect the control panel cable from the system board connector.
2. Using a Phillips #1 screwdriver, remove the screw that secures the control panel to the system.
114
Installing and removing system components