Owners Manual

Figure 80. Removing the system battery
3. To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 81. Installing the system battery
Next steps
1. Install the expansion card riser 1.
2. If applicable, connect the cables to the expansion card(s).
3. Follow the procedure listed in After working inside your system.
4. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5. Enter the correct time and date in the System Setup Time and Date fields.
6. Exit the System Setup.
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove the low profile expansion card riser.
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see Jumpers and connectors.
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
Next steps
1. If removed, install the low profile expansion card riser.
110
Installing and removing system components