Owners Manual

Figure 73. Removing the LOM riser card
Next steps
Install the LOM riser card.
Installing the LOM riser card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Orient the LOM riser card to fit through the Ethernet connectors or the SFP slot on the system.
2. Press the LOM riser card until the card is firmly seated on the system board connector and the two blue plastic snap hold the LOM
riser card in place.
3. Using a Phillips #2 screwdriver, tighten the screws to secure the LOM riser card to the system board.
104
Installing and removing system components