Owners Manual

Figure 72. Installing the IDSDM or vFlash module
Next steps
1. Install the MicroSD card.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2. Install the air shroud.
3. Follow the procedure listed in After working inside your system.
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the air shroud.
Steps
1. Locate the MicroSD card slot on the IDSDM or vFlash module, and press the card to partially release it from the slot.
2. Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Next steps
Install the MicroSD cards.
Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
102
Installing and removing system components