Owners Manual

Figure 71. Removing the optional IDSDM/vFlash card
NOTE:
There are two dip switches on the IDSDM/vFlash card for write-protection.
Installing the IDSDM or vFlash module
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Locate the IDSDM or vFlash connector on the system board.
To locate IDSDM or vFlash, see the Installing the IDSDM or vFlash module section.
2. Align IDSDM or vFlash module with the connector on the system board.
3. Push IDSDM or vFlash module until it is firmly seated in the connector on the system board.
Installing and removing system components
101