Owners Manual

3. Secure the M.2 SSD module on the BOSS card with the retention straps and screws.
Figure 70. Installing the M.2 SSD module
a. module connector (2)
b. screws (2)
c. modules (2)
Next steps
1. Install the BOSS card.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2. Install the air shroud.
3. Follow the procedure listed in After working inside your system .
Optional IDSDM or vFlash module
NOTE:
The write-protect switch is on the IDSDM or vFlash module.
Removing the optional IDSDM or vFlash card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2. Holding the pull tab, lift the IDSDM/vFlash card out of the system.
100
Installing and removing system components