Owners Manual

Next steps

1 Follow the procedure listed in After working inside your system.

2 Install a microSD card.

Installing the microSD card

Prerequisites

Follow the safety guidelines listed in Safety instructions.

NOTE: To use a microSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.

NOTE: If reinstalling, ensure that you install the microSD cards into the same slots based on the labels you had marked on the

cards during removal.

Steps

1 Locate the microSD card connector on the IDSDM. Orient the microSD card appropriately and insert the contact-pin end of the card

into the slot. To locate the IDSDM, see

System board jumpers and connectors.

NOTE: The slot is keyed to ensure correct insertion of the card.

2 Press the card into the card slot to lock it into place.

Next step

Follow the procedure listed in After working inside your system.

Removing the optional IDSDM

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 If you are replacing the IDSDM card, remove the microSD cards.

NOTE

: Temporarily label each microSD card with its corresponding slot number after removal.

Steps

1 Locate the IDSDM connector on the system board.

To locate IDSDM connector, see System board jumpers and connectors.

2 Holding the pull tab, lift the IDSDM card out of the system.

Installing and removing system components