Owners Manual

Figure 47. Installing the storage controller card
Next steps
1 Install the NDC riser.
2 Follow the procedure listed in After working inside your system.
IDSDM
The following section describes the process of removing and installing the micro SD card and IDSDM card:
Removing the microSD card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Locate the microSD card slot on the IDSDM module, and press the card to partially release it from the slot. To locate the IDSDM
module, see System board jumpers and connectors.
2 Hold the microSD card and remove it from the slot.
NOTE
: Temporarily label each microSD card with its corresponding slot number after removal.
96 Installing and removing system components